CTEK 3600 Battery
charger/conditioner
(for batteries up to 120Ah)
Price £49.95 (inc VAT) + P&P
Heavy
duty (45 watt), three step, fully automatic switch mode battery
charger for all 12v lead acid batteries 1.2-120Ah. Gives your
battery an optimum service life and increased reliability. Top
quality, Swedish design and manufacture.
Order now
|
 |
|
FEATURES & BENEFITS
- Three step, fully automatic switch mode model.
- Charges lead-acid batteries (Wet, MF, GEL and AGM) from 1.2Ah to
120Ah.
- Maintenance pulse charging increases battery life and gives superb performance.
- Charges even drained batteries.
- Pulse recover of slightly sulphated batteries.
- Three unique charging modes for use on small batteries,
large batteries and a special cold mode that is also
suitable for AGM batteries.
- Low back current drain, low ripple and input voltage independent (170-260V).
- High efficiency: 85%
- Delivered with two interchangeable connection leads, one with clamps, and one with eyelet terminals.
- The charger can be connected for months, ideal for seasonal vehicles.
- Compact design with mounting holes for permanent assembly.
- 2 year warranty.
SAFETY FEATURES
- Electronic safe, the charger will not damage vehicle
electronics. The battery does not normally need to be
disconnected from the vehicle when charging.
- Minimal gas build-up and a patent-pending spark protection
system.
- Short circuit and reverse polarity protected.
- Double insulation.
- Splash and dustproof (IP65) and approved for outdoor use.
- Progressive temperature protection.
- Tested and approved by Intertec SEMKO AB. S-marked and
conforms to the following standards:
EN 60335-1, EN 60335-2-29, EN 55014-1, EN 55014-2, EN
61000-3-2, EN 61000-3-3, EN 60555-2.
CHARGING CHARACTERISTICS
The MULTI XS 3600 has a fully automatic,
three step charge, IoUoUp:
1. Bulk
Charging where 80% of the energy is returned. The charger
delivers a constant current until the battery voltage has
reached the set level.
2. Absorption
Final part of the charge up to 100%. The battery voltage is kept
constant at the set level, during which time the current drops
gradually.
3. Pulse
Maintenance charging. The state of charge varies between 95% and
100%. A pulse is sent out to the battery if the voltage drops.
This keeps the battery in trim when not in use. The charger can
be connected for months at a time.
Using the MULTI XS 3600 gives your battery an optimum service life and
operational reliability.
TECHNICAL DATA
| MODEL
|
MULTI XS 3600
|
| Input voltage AC
|
170-260VAC, 50-60Hz
|
| Output voltage
|
Nominal: 12V
|
| Efficiency
|
85%
|
| Charging voltage
|
14.4V/0.8A, 14.4V/3.6A, 14.7V/3.6A
|
| Charging current
|
3.6A max
|
| Back current drain*
|
1.3mA
|
| Ripple**
|
Max 50mV rms, 0.13mA
|
| Ambient temperature
|
-20°C to +50°C, output power is reduced automatically at higher
temperatures.
|
| Type of charger
|
Three step, fully automatic IoUoUp,
switch mode with pulse maintenance.
|
| Type of batteries
|
12V lead-acid batteries (Wet, MF, AGM and GEL)
|
| Battery capacity
|
1.2-120Ah
|
| Dimensions (L x W x H)
|
165x61x38mm
|
| Insulation
|
IP 65 (splash and dust proof), outdoor use
|
| Weight
|
0.5kg
|
MOUNTING
The charger is easily fitted in place using two screws.
The diameter of the mounting holes is 4.5mm located as shown in
the image. The image also shows the dimensions of the charger.
EQUIPMENT
The MULTI XS 3600 is delivered with two different battery
leads, one with clamps and one with eyelet terminals, all colour
coded for easy +/- identification.
If the battery is difficult to
access, the lead with eyelet terminals can be mounted to the
battery, and the quick connectors are located so that it is
easily reached for charging.
You can also purchase additional
leads allowing you to have one lead with eyelet terminals fixed
to all your vehicles with batteries that are difficult to get
at, and charge them simply from the same charger.
|
